THANKS ALL,
I scoped all the pellets out of the hooper, then took all the screws off the hopper and removed it from the feed and the controller came with it.
Set it on a bucket because the wires are short.
The Fan and auger motor wires are black, but on the controller board it was marked fan on one connector, igniter on the middle connector and feed on the other outside connector.
I cut the wire wraps and traced the wires.
They were switched, so I switched them back and put the 18 to 20 screws back in and have fired it back .
No to see if it runs right.
This shows just how great this forum is. Less then 1 hr and its fixed.
Great members on a great forum.